TAGS: Biobased Solutions
Polymer scientists from the University of Groningen and NHL Stenden University of Applied Sciences, both in the Netherlands, have developed a polymer membrane from biobased malic acid. It is a superamphiphilic vitrimer epoxy resin membrane that can be used to separate water and oil. This membrane is fully recyclable. When the pores are blocked by foulants, it can be depolymerized, cleaned and subsequently pressed into a new membrane.
Malic Acid-based Polymers
Chongnan Ye and Katja Loos from the University of Groningen and Vincent Voet and Rudy Folkersma from NHL Stenden used a relatively new type of polymer to create a membrane that is both strong and easy to recycle.
In recent years, the researchers from both institutes have joined forces to investigate vitrimer plastics, polymer materials that have the mechanical properties and chemical resistance of a thermoset plastic. However, vitrimer plastics can also behave like a thermoplastic, since they can be depolymerized and reused. This means that a vitrimer plastic has all the qualities to make a good membrane for oil spill remediation. "
Furthermore, it was made from malic acid, a natural monomer," adds Loos.
“
The polymers in the vitrimer are crosslinked in a reversible manner,” explains Voet. They form a dynamic network, which enables recycling of the membrane.The vitrimer is produced through base-catalyzed ring opening polymerization between pristine and epoxy-modified biobased malic acid. The polymers are ground into a powder by ball milling and turned into a porous membrane through the process of sintering.
Pores to Filter Out Oil and Water
Both water and oil will spread out on the resulting superamphiphilic membrane. In an oil spill, much more water is present than oil, which means that the membrane is covered by water that can then pass through the pores. The water film on the membrane’s surface keeps the oil out of the pores, so that it is separated from the water.
The membrane is firm enough to filter oil from the water. When sand and algae clog up the pores, the membrane can be depolymerized and recreated from the building blocks after removal of the pollutants. "
We have tested this on a laboratory scale of a few square centimetres. And we are confident that our methods are scalable, both for the polymer synthesis and for the production and recycling of the membrane," says Loos. The scientists are hoping that an industrial partner will take up the further development.
Source: University of Groningen