Daikin fluoro based polymers processing aids are additives used to increase productivity and quality of PE materials during extrusion. These additives have the advantage to not compromise on PE performance as only few hundred ppm are needed.

Applications using PPA

Daikin's fluoro-based polymers processing aids are successfully suitable to various applications such as Films, Wire & Cable, Pipes, Fibers etc...

See below different applications where you can use PPA!

Blown film & cast film products:

PPA for blown and cast film products Click for the case study bullet Food and non-food packaging film
bullet Agricultural film
bullet Tapes

Wire and cable insulation / jacketing:

PPA for wire and cable insulation / jacketing bullet Telecommunication
bullet Low voltage

Extrusion blow molding:

PPA for extrusion blow molding bullet Bottles
bullet Drums
bullet Tanks

Pipes & tubing:

PPA for pipes and tubes Bullet Water and gas high pressure pipe
Bullet Sewer and drainage pipe
Bullet Irrigation tubing
Bullet Conduits

Extruded fibers:

PPA for extruded fibres Bullet Mono-filament for bailing twine, agricultural net sacks, fishing nets and ropes
Bullet Multifilament

Request a sample of DAIKIN PPA DA-910

Interested in Daikin's PPA?

Ask for a sample!


Case Studies from Fluoropolymers as Polymer Processing Aid (PPA)

Reduce PPA dosage and interactions with HALS in PE agricultural films

Polymer Processing Aids (PPA) - Fluoropolymers based additives help to reduce melt fracture, reduce die build-up and extend the time between cleanings, decrease PPA dosage with similar performance.



Downloads from Fluoropolymers as Polymer Processing Aid (PPA)


Webinars & Videos

Check out our webinars and videos about Fluoropolymers as Polymer Processing Aid (PPA)

Back to Top